Run-on time

The run-on time ensures that the load does not permanently remain switched on after a switch on command but is switched off at the end of the configured run-on time.

If a movement is detected by a linked JUNG HOME sensor cover during the run-on time, or it is switched on again with the operation of a satellite unit or linked JUNG HOME operating cover, the run-on time is restarted and the light stays on.

Early switching off of the load during an active run-on time is only possible if the Manual switching off during run-on time parameter is set to on or if a disabling function (continuous OFF) is started.

How to configure the run-on time for the JUNG HOME devices:

  1. Select the luminaire from the function bar on the Home screen.
  2. Select a JUNG HOME device.
  3. Press on the gear.
  4. Press on Parameters.
  5. Select the run-on time.